Other - morphine sulfate extended release capsules into injectable material

[emptyjug]

hi,
i have seen many recommendation regarding ms pills into injections, but nothing specific regarding this. can anyone tell me how to prepare morphine sulfate extended release 100mg (m-eslon) into an injection - im or iv. i do not have access to wheels. i have heated it previously and injected it but aftr to some research that appears to be wrong. please help. any info.

emptyjug added 18 Minutes and 56 Seconds later...

can anyone help me?

emptyjug added 0 Minutes and 35 Seconds later...

capsule - injection?

[ThirdEyeFloond]

Read the rules and avoid self-incrimination. Also SWIY should read this thread carefully : Injecting Basics, dangers of IVing pills. READ THIS before posting IV pill questions!

[Picass035]

If SWIY is going to inject these no matter what anyone says, in the best interest of harm-reduction, SWIM may as well state how to do it correctly.

If the brand is in pill form, simply heat the powdered pill powder FIRST, wait for it to smoke a bit, then shock it with cold saltwater. Draw up and inject.

If they're capsules full of small beads, using a wheel filter is recommended. But since SWIY stated not having access to those, SWIM recommends using a 3cc-5cc ORAL syringe tightly packed with a couple cottonballs inside the barrel. Draw the solution and force it through the "ghetto wheel filter" until the solution is crystal clear.

First and foremost however, READ the thread posted above. Your health/life may depend on it.

~P

[swellin]

From what ive heard, heating the pill will just cause the wax to dissolve and bind with the morphine making it impossible to filter out. Now do you really want wax going though your veins?

[Picass035]

Not sure how SWIY does it, but from SWIM's experience (as well as many others), NO wax will be drawn up with the solution. If this were true, then one would see the wax harden in the syringe after it cools down.

What SWIY might perceive as "wax" may just be some sugars/coloring that dissolves in the water no matter what. This is one of many reasons why shooting pills isn't everyone's cup of tea.

To each their own..

~P

Originally Posted by swellin

From what ive heard, heating the pill will just cause the wax to dissolve and bind with the morphine making it impossible to filter out. Now do you really want wax going though your veins?

[swellin]

When i say wax i mean the matrix inside of the pill that makes it a controlled release. And its not the same type of wax from a candle, what i mean by that is, if you stick the pill in water its not going to turn the wax hard cmon man. And i have seen the ingredients of many many morphine pills there are many subsistences that cannot be filterd out, and heating them is a bad idea peroid, we can agree to disagree but haveing that shit flying though your veins is bad. The only way to make a shot pure is you use a .22ua micron filter.

[On The Nod]

best/only way to do this properly is -

Crush up the MST- do this very well.

Add to 1-2ml of cold water and leave for 10 mins (occasionly stir).

Add cotton wool to water so it absorbs the liquid then use the syringe to filter the liquid through the cotton wool -dont add heat.

Also repeat filter with more cotton wool or use wheel filter..