Injecting - How To get out?

[grimmghost]

SWIM has a meth pipe with about a hundred $ worth in it. SWIM doesn't smoke... can SWIM get the meth diluted and out to inject? or is SWIM SOL?

Reputation Comments on this post:

price discussion

[RaverHippie]

Sure, dissolve it all in something, pour it into a container like a wider plate, then let it evaporate back into a crystal form.

[grimmghost]

figures its about as simple as it seemed, but cant rely on my assumptions, thanks.

[tweakette]

Originally Posted by grimmghost

figures its about as simple as it seemed, but cant rely on my assumptions, thanks.

Put a little water in it. Hold both holes closed with your fingers on each end, then shake it until its cleaned to clear. Pour the water from the pipe into a cap, and inject it. It's bomb like that!

Reputation Comments on this post:

make sure your info is safe

[teddybearpicnics]

Are you guys serious!?!? This sounds VERY dangerous. Isn't most of the actual methamphetamine smoked in the first couple hits, the crystalized shit is usually just the byproduct? Swim is not sure of this but god damn that seems SOOOO dangerous!!!!!

.teddy

[tweakette]

nah swim gets spun out of her mind this way. as the meth travels up the pipe is coats the sides of the glass a little every hit. if you let it sit without melting it down for awhile, it builds up even faster cuz it attaches to itself.

[Points4Life]

Yeah - it's safe. Well, as safe as injecting meth can get anyway.

SWIM only smokes when his arms need a rest - he struggles with those thin forearm veins and there's only so much room above the elbow - after a gram or so - his pipe is solid white and ready for "needle cleaning"

NOTE: typically, the 'cut' will burn away before the drug will. However, if one's dope leaves black stains on the pipe, this might not be a great idea.


BTW: If SWIY is "cleaning" just to get a single hit, the following may save you time (versus drying out on a plate)

FIRST, fill your gear with 50-60 units of sterile water/saline
THEN, squirt it into the pipe via the mouthpiece
*Eject the fluid slowly while rotating the pipe - the point being to "rinse" the stem out up front.

(Cover the hole) THEN swirl the fluid around the 'bulb' until it's clear and rinse the stem again, if need be.

Pour the water into a spoon/cooker cup/etc and fill the syringe
**USE A FILTER FOR CRYING OUT LOUD!**

Inject and go!