Bongs - Waterfall Gravity Bong in Under a Minute

[jbutler827]

I'm sure a ton of you already know this but for those of you who don't...

Here's how swim makes amazing easy waterfall gravity bongs in under a minute. All swiy needs is a hookah hose connection nossle, empty 32 ounce gatorade bottle, 1 small rubber O, and 1 lighter. All swiy does is hold the lighter under the bottom of the bottle on the round edge for a few seconds until swiy has a hole that swiy can plug up with 1 finger. then swiy should hold the lighter under the cap until it softens then carefully push and twist the nossle into the melting plastic. make sure not to cause any tears in the plastic. the shape of the nossle should be imprinted in the plastic. take the lighter and heat the bottom of the molding and use a pen to move the melted plastic to make a hole for air flow. then place the rubber O on it to make it air tight. should take less than a minute if swiy has had some practice. may take 5 or ten minutes and possibly a couple of practice runs and fuck ups at first. but once you have it down, swiy can make a gravity bong just about anywhere in no time. a great skill to have. enjoy.

and if swiy don't get this don't post untill you read it over again because it should make sense if swiy know how a gravity bong works.

p.s. hookah nossel is the part where the hose connects to the hookah. many hookahs nossels screw off and are sold in stores. can be replaced with any other type of bowl that will push into the melted plastic.

[engagenirvana]

Another really easy way to make a water fall the way my friend makes it is to take a 1.5-2 liter plastic bottle and melt a hole in the side near the bottom. Burn a hole in the cap and melt a small socket wrench attatchment into the cap and right there you got a waterfall. Really fun to smoke out of as my friend has told me.