|
| News Groups Blog Forum Chat Video Audio Images Documents Wiki Home |
|
|||||||
| Register | Tags | FAQ n Rules | Mark Forums Read |
| Notices |
![]() |
|
|
Thread Tools | Display Modes |
|
|
|
#1
|
||||||||||||
|
||||||||||||
|
'Contaminated' heroin (ie 'frazzling' and burning out quickly on the foil when being
Hi all
SWIM has, for a few days now, being buying h that frazzles (ie burns out much quicker and much more niticable, leaving a thick black line behind it when being burned/moving. It's obviously a batch that has been contaminated - it's not so bad, because smoking it for about a second it very strong; therefore losing H isn't the issue, as SWIM is effectively getting the amount of H he should be when smoking this 0.5g bag, but just much quicker. Any ideas how it could be de-contaminated tho, swim is a bit annoyed with it; swims delear is a mate and is losing custom. anyway thanks for any advice on this - anyone else encountered this particular kit? |
|
#2
|
||||||||||||
|
||||||||||||
|
In swims experience there are two kinds of Heroin contamination.
1)Bad cut = this is when the H has generaly been cut with a poor adulterant,ie sugar,paracetamol,coffee,"not caffine" or talcumpowder. 2)Infected = This is more of a mystery,some batches of heroin can get infected by the simplest of things,Finger print on foil or tiny drip of sliva even a tiny hair/strip of plastic.Were some batches swimmers can pretty much do anything to said H and it will still run fine. Infected as swim refers to it is when the H will simply not run at all,it tends to run away from itself splits appart and frazzles with a real shity taste! Only poss thing to help this is make sure foil is well well toasted(heated to burn any oils finger prints e.t.c)melt the shite and change foil again and again... 1)Bad cut best way swim finds (This also goes for above~use thicker foil,swim uses thicker foil anyway) To begin melt the powder with a very small flame,use a flicking style-little heat then pull flame away-little more heat-pull away,As soon as frazzle starts to begin stop!Now again use small flame BUT heat semi-turned beetle from the top no need to get flame to close only melt a small amount then stop. If possible at this point put the beetle on to fresh toasted foil "powder side down",Repeat first "Heat flicking technique but hold foil at 40-45 degree angle and hopefully after 1-2 lines all the shite should have burnt out? The theory behind this technique relies on melting points of differing substances ie sugar has a lower melting point than H so you are trying to burn off the sugar without burning to much H.Any thing with a higher melting point will be left behind as the H runs away!Hope this helps swiy out a little..........Q |
|
#3
|
|||||||||||
|
|||||||||||
|
Re: 'contaminated' heroin (ie 'frazzling' and burning out quickly on the foil when be
Swimhas encountered this minging tasting stuff, caramelly -pot pourri yuk yuk. Nice in a pin however but this isn't swims preffered method. £10 for lines leaves swim rather dissapointed.
rogerrinseout added 1 Minutes and 28 Seconds later... Interesting techniques mentioned by Jon-Q, stored in swims memory banks!!! Last edited by rogerrinseout; 21-10-2008 at 08:53. Reason: Automerged Doublepost |
|
#4
|
|||||||||||
|
|||||||||||
|
Re: 'contaminated' heroin (ie 'frazzling' and burning out quickly on the foil when be
Swim has had such stuff in the past and found some to maybe even have instant coffee in it. Swim even had exploding stuff (on the foil). When swim confronted swid'ing, swithd said they'd had no complaints from other swimmers and it was better in the barrel. this however is never an option for swim as swim fears needles, and wouldn't want to go down that road.
|
|
#5
|
||||||||||||
|
||||||||||||
|
Re: 'contaminated' heroin (ie 'frazzling' and burning out quickly on the foil when be
SWIM has encountered situations such as these and has come to realize that it usually is the cut.Sometimes it may not even be the dealers fault it may have already gotten to them like that already.SWIMs best bet as he may already know is to find a good source and stick with them.In SWIN's oppinion if it acts funny on the foil forget about the barrel.Stay safe!!!
|
|
#6
|
||||
|
||||
|
Re: 'contaminated' heroin (ie 'frazzling' and burning out quickly on the foil when be
Quote:
|
|
#7
|
|||
|
|||
|
Re: 'contaminated' heroin (ie 'frazzling' and burning out quickly on the foil when be
One of SWIMs fiends/dealers used to say the quicker it frazzles on a foil the better the gear... However SWIM thinks this is bollox! Just out of interest, when in powder form is it slightly orangey coloured?? Agreed with SWIJon-Q, using thicker/better quality foil does help.
|
|
#8
|
||||||||||||
|
||||||||||||
|
Re: 'contaminated' heroin (ie 'frazzling' and burning out quickly on the foil when be
Quote:
|
|
#9
|
||||||||||||
|
||||||||||||
|
Re: 'contaminated' heroin (ie 'frazzling' and burning out quickly on the foil when be
Swim has always wondered, why people shoot up the nasty shit.
You could probably easily extract the drug and clean it up some. Swim would never touch it be if he did he would have to extract. This would probably also protect your veins from going hard. Swims not judging, but i always think if your gona do drugs at least try to reduce the harm. |
|
#10
|
|||
|
|||
|
Re: 'contaminated' heroin (ie 'frazzling' and burning out quickly on the foil when be
Agreed.. but the chances of getting H4 here are slim... Don't think there'd be any doubt that it was H4 neither.. Always found that good H3 runs nicely... Remember that??
|
|
#11
|
||||||||||||
|
||||||||||||
|
Re: 'contaminated' heroin (ie 'frazzling' and burning out quickly on the foil when be
SWIM has had this rubbish. So bad he couldn't finish it for wondering what was going into his body.
|
![]() |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
| Sitelinks: | Site Functions: |