Originally Posted by mrsyavez55
Well the Mylan
patch is pretty unabusable. Yeah it's better to just wear the thing and since you can't exact the dose it would be dangerous even if you did extract the fentanyl
has done a couple thing though. SWIM put a small piece of a 59mcg patch in 3ccs of water. Put it in the microwave for 45 seconds or until it boils for a little bit(Mylan is heat sensitive and the hotter it is the more it releases). Then let it sit out until it came to room temp, usually about an hour or so. SWIM then loaded it into a needle, (Leaving thepiece of the patch) and IV'd it. It was a pretty decent hit and felt comparable to the stuff you get in the hospital. SWIM did get pretty nauseous afterwards but it worked well. SWIM only did it 3 times cause SWIM is having health problems and now, after being in the hospital, SWIM is scared to do anything of the sort. SO be careful. Not able to know how big of a hit your getting so SWIM says why not just wear it and heat it up on the skin with a blow dryer to get a bit more o fit released?
Although SWIM does not know Mylan patches, he does have plenty of experience with Durogesic
patches, which are apparently very simmilar, they both contain their Fentanyl in a plastic matrix. SWIM totally disagrees about Durogesic patches being unabusable, one just has to know what the proper way to abuse them is, and SWIM does know it.
To use them sublingually(under the tongue) is obviously easy, even more so than using gel-based Fentanyl patches. They can be cut into pieces, making dosing much more accurate then squeezing out a glob of gel. SWIM has also IV'ed Durogesic patches on several occasions, though the first time he did it was almost his last, and SWIM strongly disadvises on injecting such an insanely potent and dangerous drug
as Fentanyl. For those who are stubborn on trying it though, SWIM will post the method for IV'ing plastic matrix based Fentanyl patches like Durogesic patches.
First of all, prepair an acid solution in advance, preferrably a hydrochloric acid solution. One will need a 5ml syringe for this, to accurately dose the acid and water. If using 10% acid, fill a shot glass with 5ml saline water or otherwise boiled tap water, and 5ml acid. When using 37% acid, fill the shot glass with ~1.3ml of acid and ~8.7ml saline or boiled tap water. Swirl the shot glass a bit to mix the acid solution. Now proceed to cut the intended dose worth of patch, and place it in a glass test tube or a spoon. Add 1ml of saline or boiled tap water to the piece of patch in the test tube or spoon, and carefully add one drop of pre-made acid solution with a pipette(eye dropper bottles oftain have a pipette in their cap). Heat the solution a couple of times with a lighter for short intervals, making shure the solution does not boil. Drop a ball of cotton in the test tube/spoon and suck up the solution with a syringe. It is now ready to be injected.
Durogesic patches contain Fentanyl base instead of Fentanyl citrate, so it doesn't dissolve in water very well, that's why a tiny bit of acid is needed(remember, the dose of Fentanyl to be extracted is in the range of micrograms, so only a minute amount of acid is needed to turn it into a water soluble Fentanyl salt). The adhesive in the patch is very non-polar and doesn't dissolve in the water, so there is no risk of injecting any dissolved plastics or anything like that, you're only end up with a Fentanyl solution in water, nothing else. Like I've said earlier on in this thread though, if you do are determined to inject Fentanyl from a Durogesic patch, BE EXTREMELY CAREFUL, FENTANYL IS A KILLER!