TEK - making your own vaporizer

[0utrider]

saw it somewhere else

This is for anyone who needs to smoke a substance that must be vaporised like Meth, or crack, And doesn't want to use the shitty foil + straw method.


This works with a standard light Light bulb.

1.Pop the top of the bulb off (very top, just the black thick glass, DONT try and break off the actual silver metal part that screws in)


2. After top black plastic/glass shit is gone u now have a little hole, break the inner glass by inserting something into the hole you just created and cracking it, you will see what i mean when ur doing it.

3. after the bulb is gutted, pour a good amount of table salt in the bulb and vigorously swirl it around inside the bulb. This will remove the white "dust" That coats the inside of the bulb. Do it good, use some muscle... u can get the bulb clear as crystal.

And ur done!

You do still Smoke with a straw, just insert it into the bulb and smoke your shit, holding the straw between ur teeth, bulb in one hand and the lighter in the other. If u can make a little hole somewhere on it so there will be airflow then you will not need a straw, good luck i have only successfully done this once... It hits like the real thing tho.

Its not a pookie, but its damn good replacement, speed should never be heated on anything but glass! honestly its much better... foil is fucken bullshit and crap, take the extra 5 minutes and make this piece, you wont be sorry.

CAUTION: Because the glass is much thinner than a normal meth pipe, also not ment for smoking drugs it will crack and shatter if you heat it too hot too quick. Start off by moving ur lighter all around the bulb, you want to get the entire bulb hot and evenly heated. Not some parts hot and some parts cold thats what cracks it, it needs to be evenly heated for a few seconds, then u can start applying (gently) flame to the bottom of the bulb which is where ur shit should be collected.

Id advise against using water to clean the inside of the bulb unless u have a lot of time to sit around and let it dry. Its hard 2 dry the water up from inside the bulb, it will still work if theres water in it, but many times if the sides are wet ur shit will stick and be scatterd throughout the bulb making it a pain in the ass 2 smoke.

Once i threw like .4 of crystal in there and there was way more water than i expected.. ALL the shit was completely dissolved and appeared as a puddle of water.

Other times the sides of the bulb would be wet and the crystals would hit the sides and stick... also not good, u want ur shit collected in the bottom of the bowl for it 2 smoke right.


If ur shit does get dessolved in water dont worry, just carfully boil off the excess water. (Id inhale the steam also... because there will be meth in it, its a real pain in the ass, seriously try and aviod it)