Uniformity Of Pill Batches.

[fnord]

its my understanding that diffrent pils from the same batch can have diffrent amounts of MDMA/whatever from them.

is this from improper mixing? if so what can be done when making homemade pills to prevent this?

could one just dissolve all chemicals into a solvent then evap and be left with a uniform consistency to work with?

[Silentscream]

Originally Posted by fnord

its my understanding that diffrent pils from the same batch can have diffrent amounts of MDMA/whatever from them.

is this from improper mixing? if so what can be done when making homemade pills to prevent this?

could one just dissolve all chemicals into a solvent then evap and be left with a uniform consistency to work with?

Im guessing that you could do that, Lejunk posted a TEK explaining it - quite a simple process.

From there you should be left with just the active ingredients which could be weighed and dosed appropriately.

[Pinkavvy]

"profesionaly" pressed pills will often have a slight variation in the ammounts of active chemical from pill to pill in a single batch due to improper calibration of the feed shoots on the "profesional" presses. But differance in pills in the same batch is usually very slight. The main question one should ask is to know if swiys two pills that look alike are even from the same batch, let alone the same makers. If one is certain the pills are of the same batch (usually packaged together and exactly the same in size, color, and weight) then it is likely they are so similar in ammounts of active chemicals that the effects wil not be differant.

[Pinkavvy]

I see I have newbie status... was wondering why I was so limited in forum access.
grrr

[fnord]

^^is that your own opinion or is there a source avvy?

[Pinkavvy]

That is an opinion based on much research in testing many pills by a harm reduction group that swip is involved with over the last many years, and from technical knowledge of pill presses that swip has. I would say that there are other sources I am sure to verify the info, but in my limited time crunch I can't list any of the sources.

[Lettish]

I cannot remember if this is acid or ecstasy, but in terms of amateur/cheap production, the batch is made vertically (for some reason I don't remember) and much of the solution "falls" to the bottom, so therefore the bottom half is stronger than the top at the end of production.

However, reading over what I just typed sounds absolutely ridiculous. So maybe I am seriously mistaken.