hi there: FOR THOSE WHO WANT TO INJECT MORPH PILLS
Just letting you all know that there is an easier way to extract morph from your pills than having to buy and build a labratory. The method is so simple and takes 5-10 mins with no chems just a simple prep method. This method stops all the shit from getting in your viens and is very safe. It also works perfectly as i have used this method for years with zero danger. But before i go through it i want to say the following.
There is no need to go to such a dramatic measure for extraction in using all these instruments and methods. You end up losing product and time. YOU DO NOT NEED TO COOK THE PILLS IN A SPOON EITHER AS THIS FUCKS UP THE CHEMICLS AND THE WAXES IN THE PILLS. MORPHINE
IS SOLUABLE IN WATER! THE WAXES ARE NOT!! DO NOT COOK A CRUSHED PILL ON A SPOON AS IF IT WAS HEROIN
!!! the pills are professionally engineered in a lab, heroin is not.
Anyway with that said now lets go onto EZ method.
Depending on where you live it may be difficult to get good needle tips and filters. In australia we have these at needle exchanges so just ask for them. you pay have to pay $1 or two but thats it!
1. Your pick and barral for injection (obviously!) try to use a five ml barrel minimum 1mls a re useless. I use 10ml barrels as they fit more than enough.
2. get some steriod tips as they are wider and draw the product up quicker.
3. a small cup (pref a shot glass with a curved base.)
4. a spoon and some paper.
5. some wet towls (like the ones from fast food joints eg KFC.) you can also use swabs. these are usually included as part of your pick pack!
and thats it!
1. wipe the pill with the swab to get the surface paint off. you'll only need 1 or two, the shit comes straight off.
2. lightly dry the pill/s (if you have 30ml pills use about 3 of 'em depending what your used to) i usually use 60ml or 100ml tabs.
3. put the pills in some paper folded in half. tap a desert spoon gently over them to crush them up. Then use the curved part of the spoon to roll over the broken bits. It doesn't have to be total powder so don't be too fussy.
4 pour the crushed tabs into the shot glass and add about 8ml-10ml of clean sterilised water and use the cover tip of the pick or some other clean object as a stirer and stir for a about a minute. you can crush the powder more if you want during this time.
5. Let sit for about 5 min (i usually have a shower) When you come back the un-important shit will be sitting on the bottom. this is all the waxes etc. If you want you can give another brief stir and let sit for a min or 2.
6. attach the filter to the barrel (without the pick) and attach the steroid
needle tip to the other side of the filter and carefully draw up the water. If you don't have or can get a filter use a cigerette butt and break it up a bit and draw thru that! be carefull not to get the tip into the powder at the bottom as the needle tip can get blocked and its a pain in the arse to clean it midway. the filter will stop the shit but if using a cig butt there may be more shit picked up.
7. take off the filter attach your tip and you're done.
ps add some water to the remaining powder as there is still some more morph in there and you can have a second blast or save it for later, but it won't be as strong. its just to keep you up iof you have to go to work etc.
Hope this helped!
pps be sure to always clean the injection site with a swab! dirt on the arm is the main reason people get absesses and so on.
ALSO, PLEASE PASS THIS METHOD ON TO ALL WHO ENGAGE IN SUCH DANGEROUS HABITS, ITS EASIER AND SAFER THAT PLAYING LAB TECH