|
| News Groups Blog Forum Chat Video Audio Images Documents Wiki Home |
|
|||||||
| Register | Tags | FAQ n Rules | Mark Forums Read |
| Notices |
| Ecstasy (MDMA, MDEA, MDA) Ecstasy (XTC) pills and pure MDMA |
|
|
Thread Tools | Display Modes |
|
#1
|
|||||||||||
|
|||||||||||
|
cleaning ecstasy pills via a simple acetone wash
This is a thread that SWIM previously wrote on another forum. However, the results are remarkable to say the least! SWIM feels as though he has perfected the art of cleaning cocaine, so he thought he'd take a turn at ecstasy this time around. Enjoy!....................
As most of you are probably aware, SWIM wrote the "cocaine purification......the absolute final thread" thread in OD. Well, SWIM's decided to diversify and play my hand at cleaning ecstasy. Good news, it works! And it works really, really well! Last night SWIM took some yellow Louis Vuittons and they felt like anything other than pure MDMA, though they certainly tested well for it with the EZ Extreme. Afterwards, SWIM could only attribute the experience to that of MDE, though SWIM really didn't know for sure. The problem, as most of you are aware, is that there is no test to differentiate between MDMA and MDE. And the problem with that is that one of those two is great while the other is, well, crap! All day long SWIM was going back and forth wondering if it was indeed MDE or perhaps caffeine, seeing as how there's no test for that either. After agonizing over it for hours, SWIM decided to perform a simple anhydrous (water free) acetone wash on 4 pills. Caffeine is entirely soluble in acetone while MDMA is not. Therefore, you'll simply be rinsing the caffeine right off of your pills, or I guess powder at this point. Well low and behold, these previous pills, now turned powder that SWIM thought might be MDE last night has been turned into nothing less than the smoothest, most beautiful molly type of MDMA high SWIM had in a very, very long time. Like SWIM said, SWIM crushed up 4 pills and then washed them in acetone. The result was about 1/2 of what SWIM originally put in, but that's because there's no more fillers, binders, caffeine or a host of other nasty byproducts. SWIM is doing this shit right now and it is nothing like last night. And this is back to back nights as well! SWIM's been doing E since it was legal and SWIM will tell you, this is as good as it gets folks! That, and it's so easy to perform a small child could do it. If nothing else, it will drastically help to clean your pills of byproducts, binders and fillers, some of which cause stomach discomfort etc. Let's put it this way: SWIM WILL NEVER DO A PILL AGAIN UNTIL HE CLEANS IT FIRST! There's just way to much, who knows what, in these pills nowdays to not do it. Personally, SWIM is going to do an anhydrous acetone wash followed by a cold water extraction on all my pills from now on. The same pills SWIM took two nights ago vs. the same cleaned up one's SWIM took last night are so far apart it's like a whole different drug! And that's in a good way. Did SWIM also state that when they were dirty he had stomach cramps? But absolutely none after cleaning them. So what does that tell ya? Well, you've got everything to gain and nothing to lose, that's all.............. Okay, SWIM says it's getting pretty hard to still read the screen, but he'll continue on as best he can. He is a soldier! SWIM will outline below how to make hardware store acetone anhydrous by the use of epsom salts turned anhydrous magnesium sulphate with heating. But may SWIM strongly suggest that you just skip that and simply order lab grade anhydrous acetone via a chemical supply company. It's much better quality and it's not that expensive either. Nor is it a watched item. SWIM would order a 1 liter bottle, it's all you'll need for awhile. If not, you can make simple hardware/home store acetone anhydrous with the following directions: When using 4 tabs as the control, take a tall shot glass or a 50 ml. glass beaker and fill it to 20 ml.s with anhydrous acetone. If you don't have anhydrous acetone, simply go to Home Depot, Menards, or Lowes and purchase a 1 liter can of acetone in the paint section. Also grab a bag of epsom salts. When you get home, spread some epsom salts out onto an aluminum covered baking sheet. Bake the salt for 2 hours at 400 degrees F. At the two hour mark, you should now have a greyish looking ash, better known as anhydrous magnesium sulphate. Scrap up about 15-20 grams of the magnesium sulphate ash and pour it directly into the can of hardware store acetone. Once it's all in, replace the lid and shake vigorously for about 5 minutes. This will insure that the magnesium sulphate has completely absorbed any and all of the water/alcohol that's in the hardware store acetone. Let stand for 24 hours to insure that all of the mag. sulphate has fully absorbed all of the water/alcohol and has thus sunk to the bottom of the can. Now, never pour from the can again. We want that pile of goo, now at the bottom of the can, to stay there. So therefore, use a glass eye dropper to get down inside of the container to extract the acetone. Pour 20 ml.s of anhydrous acetone into a 50 ml. beaker and add your finely chopped pills, now powder, into the acetone. Stir thoroughly for about 2-3 minutes. Cover and let settle. Let the acetone on top become clear while the molly crystals lay directly on the bottom while the few acetone insoluble and flat looking cuts lay directly on top of the crystals. Once settled, carefully pour out the acetone and the flat looking cut that wants to pour out as easily as the acetone, stoping just short of any actual MDMA crystals falling out with them into a filter. Cover the filter and repour 10 more ml.s of fresh acetone into the original beaker still containing your mostly MDMA crytals with a little residual flat powder stuck to the side from the original pour. Cover and let settle. Once again, carefully try and pour into the original filter, just the flat powder looking substance stoping just short of the crystals. This time, you should have at least 98% pure MDMA crytals left in the beaker, and just a trace of powder still, if any. Remove, but don't throw away the original filter paper. Replace with a fresh new filter paper, swirl the final washing and pour the entire contents into the new filter paper. Cover. Pour a little fresh acetone into the beaker to gather any remaining crystals and pour them into the fillter paper. Cover and let drain thoroughly. Remove and press the filter paper containing the nearly pure MDMA crystals in between a few paper towels to absorb any excess acetone. Preferably leave inside of the filter paper and let air dry in a non-humid environment for at least 48 hours. Open, crush up, pour the newly cleaned MDMA crystals into 120 mg.s capsules, drop and enjoy! ![]() Once finished and desperate for more, take the original filter paper containing mostly cuts along with the few MDMA crystals that fell thru with the original pours and crush the mixture up thoroughly. Pour the entire contents onto one side of a wax coated paper plate. Take the plate in your hands and tilt it slightly towards you with the pile at the top. From underneath, gently tap on the pile and the crystals will pop out of and fall directly down the plate towards you. Stop tapping when the powder starts to fall with the crystals. Gather the crystals and put them on a seperate plate. Push the entire pile back to the top and keep repeating this tedious process for about 10-15 minutes until every last crystal has been seperated. Discard the powder, pour the crystals into 120 mg. capsules, drop and enjoy.........again! courtesy of the now semi-retired and new daddy, Le Junk ![]() Last edited by Jatelka; 11-06-2009 at 12:00. Reason: Updated as taken from post # 70 of this thread. Should be easier to understand now. Enjoy! |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TEK - TEK: Salvia Extract w/ pics | 0utrider | Salvia divinorum | 4 | 09-08-2009 23:26 |
| Sitelinks: | Site Functions: |