Extraction of morphine from MScontin

[Rocco.Siffredi]

Swim will detail the process here, with pictures, for those of you who
wish to try it yourself.


Personally, SWIM prefers morphine from these pills because he can garauntee what he's injecting, unlike when SWIM gets dope off the street. SWIM suspect SWIM getting 95-99% of the morphine out. Also, since SWIM morphine isn't cut with anything, like milk sugar, it doesn't do any damage at all to the vein. SWIM has hit in the same two small veins everyday, up to 5
times for 5 months. SWIMs amazed at how morphine+h20 does no damage to the vein, but cut it with a little milk sugar and your veins go down
after a while.

To extract the morphine from the pill you will need:

1. Pill Pulverizer
http://img460.imageshack.us/my.php?image=pulverizerandsyringeer7.jpg
2. 3ml Syringe
3. Wheel Filter
http://img460.imageshack.us/my.php?image=wheelfilterqs3.jpg
4. Pyrex Beaker
5. Electric Stove
6. Frying Pan
7. Insulin Syringe


The pills SWIM prefers are the blue stamped ABG/100 Watson brand 100mg
Mscontins. These are the best for the method, but it will work with
any pill.

Pichttp://img358.imageshack.us/my.php?image=pillnl4.jpg)


1. Remove the coating from the pill

2. Turn the stove on to med heat

3. Put the pill with the coating removed into the beaker and put the
beaker into the pan on the stove.

http://img358.imageshack.us/my.php?image=pillinsidebeakerhk2.jpg

4. Shake the beaker back and forth while still making contact with the
pan, until the pill beaks into pieces.

http://img360.imageshack.us/my.php?image=crushedinsidebeaker2fz4.jpg

5. Put the pieces in the pill pulverizer and crush them.

http://img460.imageshack.us/my.php?image=firstcrushvf0.jpg


6. Put the crushed pill back into the beaker and back onto the stove,
shaking, for about another 2-3 mins. Don't let it burn by shaking and
taking off the heat every 10 seconds.


http://img460.imageshack.us/my.php?image=beakercookingend1ey7.jpg

http://img460.imageshack.us/my.php?image=cookingafterfirstcrushey6.jpg

7. Take off the heat and put the crushed pill back into the pill
pulverizer. This time the pill with turn into fine dust.

http://img358.imageshack.us/my.php?image=powderlg7.jpg

8. Pour this dust back into the beaker, and put it back onto the
heat.

http://img358.imageshack.us/my.php?image=beakercookingendfx4.jpg

9. After about 20 seconds on the heat shock it with 2ml of cold water,
and take it off the heat.

http://img182.imageshack.us/my.php?image=solutionwithwaterbp2.jpg

10. Suck this solution up into a 3ml syringe through a large cotton,
or cig filter.

http://img460.imageshack.us/my.php?image=unfilteredsolutiongx1.jpg

11. Push this through a wheel filter ( I use a 13mm .45u) into a clean
sterile syringe.

http://img358.imageshack.us/my.php?image=wheelfilterfinishedhl1.jpg

12. Now the solution is completely clear, consistency of water. It's
beautiful to look at.

http://img360.imageshack.us/my.php?image=filteredsolutionmp1.jpg

13. Split the solution into 2 50mg shots, always use a 1ml insulin
syringe to keep from blowing a vein. Taking the whole shot at once is
too much for anyone without a high tolerance. It's even a lot for
someone with a tolerance. So be careful.

http://img460.imageshack.us/my.php?image=insulinlr5.jpg



BTW- Be careful not to burn the pill. You have to continually shake the beaker and keep the contents moving, to keep it from burning. There should be only a small amount of discoloration. DO NOT carmelize the pill.

The method for the Mallinkrodt version is different in that you can crush the pill before heating it, because it breaks down into a fine powder. The watson version will not crush into a powder, so you must do the process explained above to get it into a fine powdered state. The mallinkrodt version takes much less heating.

There is an art to the process, and you have to get the hang of it. Once you take that first shot of morphine, there is nothing that can compare. Good luck. - Rocco.