A Guide To Smoking Salvia divinorum

[BA]

A simple procedure for this process, which is to use a conventional hash oil pipe. A hash oil pipe is made by creating a bubble or bowl at one end of a glass tube, with an opening at the top. Although hash oil is no longer commonly available4 these pipes can occasionally be found in stores. A hash oil pipe allows better visibility of the melting and vaporization, and better confinement of the vaporized material against escaping without being inhaled. Even with a hash oil pipe the technique requires precision. The use of a micro-torch or "jet flame" lighter is essential, not only due to salvinorin A's high boiling point, but also because a conventional lighter will coat the outside of the pipe in carbon, obscuring visibility of the melting/vaporization process.The flame must be continually moved over the bottom of the bowl until the material has melted. These torches are hot enough to cause the bowl to quickly expand and buckle if the flame is kept at one point on the bowl. This causes the solid salvinorin A crystals to disperse over a large area inside the bowl, which does not allow for efficient vaporization. It is important that only self-extinguishing torches or lighters are used in this process, as salvinorin A takes effect very rapidly. One does not want to be traveling through hyperspace while a lit torch is burning at their side


----------------------------------------------------------------------------------------------
Dried leaves can be smoked in a pipe. They need to be smoked hot and the smoke must be inhaled deeply and quickly to have an effect. Because salvinorin requires high temperatures to vaporize, it is best to hold a flame immediately above the leaves, drawing it down into the leaves the whole time you inhale. The leaves can be smoked in a short-stemmed tobacco pipe, glass pipe,in a bong, or in a "steamroller" pipe. Fill up a medium size bowl with leaves. Use a hand-held jet butane lighter that will go out when you are no longer pressing it, not a match. Have a large ashtray or tip-proof bowl to set the pipe in when you feel you've had enough. Remember that when you are immersed in the experience you may forget you are holding a lit pipe. You could drop it, causing a burn or a fire; therefore, it is best to have a sitter present when smoking. First effects will be noticed within a minute of inhaling. After 5-6 minutes the effects will gradually begin to subside. The total duration of the experience may be less than 30 minutes or as long as an hour.


Extract-enhanced leaves can also be smoked. Extract-enhanced leaves can be very strong and should only be smoked when a sitter is present. It is possible to vaporize leaves or extract in a special vaporizer that heats up material without burning it. Vaporization can be deceiving. Because very little smoke is produced, it is possible to inhale a very large dose without realizing it. Anyone trying vaporization absolutely MUST have a sitter present.


Vaporization of pure Salvinorin A is also possible, but it is not recommended! Unless the dose has been measured very precisely, this is extremely dangerous, as it's very easy to vaporize too large a dose. To be done safely, vaporization of salvinorin A requires weighing the dose on a very precise chemical balance capable of weighing in micrograms (millionths of a gram). These analytical balances cost well over $1000. There are now available standardized doses of Salvinorin A on leaves, using such preparations enables one to inhale a known precisely-measured dose of salvinorin A. This makes it possible to experiment with salvinorin A without having to buy an analytical balance, and it greatly reduces the risk of overdose.