TEK - Best way to make freebase?

[killerfromsky]

What out of these two methodes is best?

1) Put 1g of cocaine per 60mL water
2) Start adding ammonia while stirring
3) Cocaine base will begin to sink as it precipitates, stir it in well as the impurities will stick to the sides and base will sink
4) After the base settles the water should be clear and adding more ammonia should not cause the water to turn white
5) Once clear and settled mix up to suspend the base and pass through a filter wash with clean water and let dry

or:

1)Mix about 1 gram of coke and 10 ml of water in a small vial.
2) Slowly add drops of ammonia to the solution. A white milky precipitate will form. Stop adding ammonia when additional drops no longer result in precipitation.
3) Add 5 ml of ethyl ether, close vial, and shake. The precipitate (freebase) will dissolve in the ether.
4) Siphon off the ether with a pipette (ether and water don't mix), and slowly drip it on a plate.
5) Let dry

What tek gives best results?

[cra$h]

swim leans towards this method: http://www.drugs-forum.com/forum/showthread.php?t=34254
simply because of its simplicity for the most part, but isn't legitamite freebased cocaine. Not sure why, but read somewhere it isnt.

[killerfromsky]

SWIM just doesn't like crack, altough never tried it.
SWIM just wants to know wich of these 2 methods is best.

killerfromsky added 2 Minutes and 37 Seconds later...

Also it seems that the 2 methods for freebase are even simpler then that crack tek.

[cra$h]

yea, it does sound pretty easy. For some reason I was thinking amonia was hard to get. but on the other hand, ether is hard to get, but there's ways to purify it from starter fluid or some shit, I know it's on the forum somewhere.

[killerfromsky]

Originally Posted by cra$h

yea, it does sound pretty easy. For some reason I was thinking amonia was hard to get. but on the other hand, ether is hard to get, but there's ways to purify it from starter fluid or some shit, I know it's on the forum somewhere.

Ammonia is easy to get? The household ammonia is probably just pure ammonia with some water. So dont even need pure ammonia.

And ether is also easy, pharmacies have it? They'll sell it.

[killerfromsky]

SWIM still doesn't know what tek is best?

And also, after adding amonia, should SWIM put the solution in a new bottle? As the impurities will stick to the sides?

Also could SWIM use a plastic test tube?


And in some tek the solution is heatened to just before boiling? Is this necessary?

Could someone please give SWIM a decent, working TEK in steps, with the ether TEK?

[Apotek]

Don't know that you'll be able to get ether so easily in the states from a pharmacy. I've never carried if for dispensing purposes for customers. There isn't a clinical indication for it. Doctors would never write a script for it.

A compounding pharmacy may have it. A chemical supply store may have it. You'll probably have to rely on some other form of base. I can think of a few, but I would be hesitant to recommend them in concern that someone would experiment with a suggestion.

[killerfromsky]

Ok, SWIM didn't know that.

But SWIM his dad is a doctor and his mother is a vetrenarian.
So they both have it.

SWIM will go with the ether method. Since then there will be a little bit more cleaning.

Thank!